87
5.3. HDD Mode Setup
On the main screen, press ∧ and ∨ to move to the following screen, and then press Enter.
Sub-menus will appear where you can use ∧ and ∨ to navigate.
Select an HDD operation mode, and then press Enter. The following warning message will
appear. Normal is the non-RAID mode.
After displaying this warning message for 3 seconds, the screen moves to the next screen
corresponding to the selected mode.
Press Enter to change the HDD mode to the selected mode. To move back to the previous
phase, press ESC. To cancel the new settings and move back to the main screen, hold down
ESC for 2 seconds or longer.
While the new RAID mode is being configured, the following messages appear in order,
informing of the progress and remaining time.
Rebooting system
is in Pro
To Next Page
Loading...
