90
5.4. Removing HDDs
On the main screen, press ∧ and ∨ to move to the following screen, and then press Enter.
The screen shown below appears where you can use ∧ and ∨ to select the HDD to remove.
Select the number for an internal HDD or an external HDD bay, and then press Enter. Upon
pressing Enter, the following messages appear while the selected HDD is being removed.
Once the [Done] message appears, you may physically remove the HDD from the product.
When selecting an HDD that is not available or connected, the following message appears.
Note
The number for an internal HDD or external HDD bay is determined depending
on which product port that you connect to. Available numbers are 1, 2, 3, and 4
from the upper left and right to the bottom left and right. Please Refer to "Chapter
2. Part Names"
Remove Ext Bay[1]
[DONE]
Check HDD to Remove
Please Try A
To Next Page
Loading...
