18 2A. Device Basics
Installing the Battery
䊳 See “Setting Up Your Device” on page 2.
Removing the Battery
1. Make sure the power is off so that you don’t lose
any stored numbers or messages.
2. Grasp the device firmly, locate the cover release
latch, and then place your fingernail in the opening
and firmly “pop” the cover off the device.
3. Carefully remove the battery from the device.
Charging the Battery
Keeping track of your battery’s charge is important. If
your battery level becomes too low, your device
automatically turns off and you will lose any information
you were just working on.
1. Connect the USB cable to the charging head.
2. Insert the USB cable into the device’s Charger/
Accessory jack.
3. Plug the charging head into a standard AC
power outlet.
Note: Although the battery comes partially charged, it is
recommended you fully charge the battery before
using your device for the first time.
SPH-M930_Boost.book Page 18 Friday, September 2, 2011 11:04 AM
To Next Page
Loading...
