6
Remote Control Operation Range
The remote control can be used at a maximum of 5
metres from the unit’s remote control sensor, and
within 60° in front of the unit.
The operating distance may vary depending on the
brightness of the room.
Power Rec
CH+ CH- R
30° 30°
5M
1. Squeeze the cover lever and lift the
battery cover to access the battery
compartment of the remote control.
2. Insert two AAA size batteries
(included). Ensure the polarities (+
and –) of the batteries match the (+)
and (–) ends indicated in the battery
compartment.
3. Close the battery compartment cover.
Installing Batteries in the Remote Control
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could
cause fire, personal injury or damage property.
• Only use the battery type indicated in this manual.
• When the batteries are exhausted, the remote will not function. Replace both batteries at
the same time with new ones.
• Do not install new batteries with used ones and do not mix dierent types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with
local regulations.
Handling the Remote Control
• Do not drop or impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the batteries from the remote control when not in use for a long period of time,
as the batteries may leak causing corrosion that may result in physical injury and/or
property damage, including fire.
Remote Control
SHDFSAT12_IB_V2.indd 6 13/06/2013 12:19
To Next Page
