To Next PageTo Next Page
Need help?Do you have a question about the Sansui CA-2000 and is the answer not in the manual?
General| Type | Stereo Preamplifier |
|---|---|
| Input Sensitivity | 2.5 mV (MM), 150 mV (line) |
| Signal to Noise Ratio | 90 dB |
| Channel Separation | 70 dB |
| Output | 1V (Line) |
| Input Impedance | 50 kOhms |
Guidelines for safe placement, avoiding hazards like moisture and heat.
Precautions for safe cable and power connections to prevent damage.
Warning against removing unit covers or bottom boards to prevent hazards.
Details on output voltage, input sensitivity, and impedance.
Includes distortion, frequency response, and RIAA deviation.
Verifies connections and operating procedures when no sound is heard.
Guide for connecting turntables to PHONO inputs.
Instructions for connecting a tuner.
How to connect tape decks to TAPE inputs.
Managing unused terminals and short pin-plugs to prevent noise.
Adjusts input sensitivity for the PHONO-1 circuit.
Adjusts input resistance for the PHONO-1 circuit.
Explains POWER switch, OUTPUT SELECTOR, and PHONES jack.
Details INPUT SELECTOR and TUNER selectors.
Explains the VOLUME and BALANCE controls.
Guidance on using the auxiliary (AUX) inputs.
Proper grounding to reduce hum and noise.
Steps for recording audio sources to tape decks.
Procedure for dubbing audio from one tape to another.
Steps for playing vinyl records.
Steps for playing audio tapes.
Troubleshooting record playback issues like hum or distortion.
Addressing hiss and noise during tape playback.
Controls for tone and filter effects.
Eliminates high-frequency noise.
Eliminates low-frequency noise.
Adjusts treble frequency response.
Adjusts midrange frequency response.
Adjusts bass frequency response.
