"Stop&Go" management
This menu allows you to activate "Stop&Go" and to select the pause time.
"Stop&Go" function: in this mode, you must press and hold the "start" button (18), until the
timer has elapsed, in order to deliver the dose. The motor stops and pauses when the
portafilter is removed. The timer continues when the portafilter is returned, except if the
time between the 2 maintained presses is greater than the set pause time.
The pause time can be set from 1 to 10 seconds.
Quick modification
This menu allows you to set the authorisation for quick modification of the active recipe
directly from the home screen.
Management of burrs wear and history of the number of sets replaced
Set of menus that allow you to check the wear indicator of the burrs set, record the
replacing of a burrs set and to consult the appliance's history.
A wear indicator for the burrs is displayed starting from 95% wear.
The indicator is erased once replacing the burrs set has been confirmed.
Event log
Lists the main events in the life of the appliance such as: the number of burrs set
replacements with the rate of wear, incident history (overloads, overheating, blocking, etc.)
SETTING THE APPLIANCE
Step 1: Grind setting
CAUTION: Modifying the grind setting always entails setting the
recipe timer.
Note: Never operate the appliance with the two burrs in contact. Putting the burrs in
contact can cause the grind to jam in the grinding body and premature wear of the burrs.
The appliance is factory set so that the "0" mark on the graduated plate of the nut (24)
corresponds to the finest grind without the burrs touching each other (fig. A).
The appliance is delivered with the grind set to the espresso type, about mark 12 on the
adjustment nut (24).
1. Pull the indexing lever (23) to unlock the adjustment nut (24).
2. Tighten the adjustment nut (24) clockwise (right-handed thread) one or two
notches for finer grinding.
3. Loosen the adjustment nut (24) anticlockwise (right-handed thread) one or two
notches for coarser grinding.
4. Release the indexing lever (23) to lock the nut (24).
5. Deliver 1 to 2 doses of coffee to check the grind setting.
To Next Page
Loading...