Safety
Safety, Operation and Maintenance Manual - Sep 2012 2-41
SY115C9/135C/155H Crawler Hydraulic Excavator
Improper handling may cause battery explo-
sion or loss of machine control, resulting in
personal injury and death. Never use jumper
cables to start the engine unless necessary.
Contact your Sany distributor before such an
attempt.
●
Using jumper cables to start the engine
needs two persons working together with
one seated in the operator seat and the
other handling the battery.
●
Wear goggles and rubber gloves before
starting the engine with jumper cables.
●
When connecting a normal machine with a
faulty machine with jumper cables, battery
voltage of the two machines shall be the
same. Be careful not to allow the two ma-
chines to contact with each other.
●
Turn both start switches to OFF position
when connecting the two machines. Oth-
erwise, the machine may move and cause
danger when it is powered on.
●
Start with the positive terminal when con-
necting the jumper cable. Start with the
ground or negative terminal when discon-
necting the jump cable.
●
When disconnecting the jumper cable, take
care not to allow the clips of jumper cable
to contact with each other or with the ma-
chine.
Ether is a liquid used for cold start, which is
extremely fl ammable and explosive. Read the
instructions on the ether container before ap-
plication.
Never use ether if the engine is equipped with
spark-plug preheater or other forms of pre-
heater.
2.4.1.9 After starting the engine
Run the engine at low idle for 3 to 5 minutes
after engine startup, and check the running
parameters and make sure they are normal
To Next Page
Loading...
