- 60 -
㻌
㻌
㻌㻌㻌㻌<Initial data in non-volatile memory>
Data Initial Remark
Set temperature
37.0䉝
Set O2 density 20.0%
Set CO2 density 0.0%
Ring Back time 30 min.
Temperature zero calibration
0.5䉝
Log interval 6 min.
CO2 zero calibration 500 Corrective coefficient
CO2 span calibration 700 Corrective coefficient
CO2 sensor gas cell voltage 4000mV For CO2 zero calibration
Key Lock 0 0:OFF
1:ON
24hours UV mode 0 0:OFF, 1:ON
DAQ mode 0 0:Local
1:Remote
Remote alarm 1 0:Linked with buzzer
1:Not linked with buzzer
LCD backlight 0 0:Blue, 1:White
CO2 sensor gas reference voltage 4000mV For CO2 zero calibration
Model code 0
Function doe 0
DAQ communication speed 0 0:2400bps
1:4800bps
2:9600bps
DAQ communication ID 0
High/low temperature alarm
±1.0䉝
High/low CO2 density alarm ±1.0%
High/low O2 density alarm ±1.0%
Alarm delay time 15 min.
Dooer alarm delay time 2 min.
UV lamp timer 0 min.
Door heater balance 6 Current conductivity ratio
Bottom heater balance 10 Current conductivity ratio
Key lock password 0000
CO2 valve control 0 0: CO2 valve A
1: CO2 valve B
N2/O2 valve control 0 0: O2/N2 valve A
1: O2/N2 valve B
PCB test mode 0 0:OFF, 1:ON
Demo mode 0 0:OFF, 1:ON
CO2 Auto changer mode (option) 0 0:OFF, 1:ON
Standard gas calibration (option) 0 0:OFF, 1:ON
H2O2 decontamination (option) 0 0:OFF, 1:ON
UV lamp option 0 0:OFF, 1:ON
Primary H2O2 misting time 7 min.
Primary H2O2 preservation time 0 min.
Secondary H2O2 misting time 0 min.
Secondary H2O2 resolution time 90 min. UV resolution
UV lamp accumulation time 0 min.
Standard gas CO2 density 5.0%
Standard gas o2 density 5.0%
H2O2 decontamination temperature
45.0䉝
O2 zero calibration 500 Corrective coefficient
O2 span calibration 500 For N2 mode
500 For O2 mode
O2 sensor gas cell voltage 200mV For O2 zero calibration
㻌
To Next Page
Loading...
