- 68 -
㻌
㻌
㻌
㻌
㻌
䢼 䢹䣕 䣶 䣧 䣲
䣥 䣭 䣧 䣦䣴 䢼 䣎 䣱䣆 䣱 䣱
䢲 䤑 䣅䢼 䢶 䢷 䢰䣖 䣧 䣯 䣲䣮 䣧 䣦䣈 䣣 䣫䣱 䣹 䣧 䣴( 䣴 䣴 䢵 䢷 䢼 䣒
䣯 䣫 䣰䣯 䣫 䣰
䢺䢻䢲
䣮 䣸 䣧䣔 䣧 䣵 䣱䣗 䣘䣥 䣱 䣰䢴 䣆 䣧䣊 䢴 䣑
㻌
㻌
㻌
㻌
䣊 䢴 䣑 䢴 䣆 䣧 䣥 䣱 䣰 䣶 䣣 䣯 䣫 䣰 䣣 䣶 䣫 䣱 䣰 䣕 䣶 䣧 䣲 䢼 䢺
㻰 㼑 䣥 䣱 䣰 䣈 䣣 䣫 䣮 㼑 㼐 㻚
䣇 䣴 䣴 䢵 䢷 䢼 䣒 䣱 䣹 䣧 䣴 䣈 䣣 䣫 䣮 䣧 䣦 䣖 䣧 䣯 䣲 䢼 䢶 䢷 䢰 䢲
䣅
䣒 䣮 䣧 䣣 䣵 䣧 䣔 䣧 䣯 䣱 䣸 䣧 䣊 䢴 䣑 䢴 䣗 䣰 䣫 䣶 䣆 䣱 䣱 䣴 䢼 䣗 䣰 䣮 䣱 䣥 䣭
㻌
㻌
㻌
<Power failure during H2O2 decontamination mode>
㻌
If power fails while H2O2 misting process (Step 4) or UV resolution process (Step 7), UV resolution
will reset and repeat.
㻌
If power fails while H2O2 misting process (Step 4), “Decon Failed” will be displayed and “Err35: Power Failed”
will be displayed on the message bar.
If power fails while UV resolution process (Step 7), “Decon Failed” will be displayed and “Err37: Power Failed”
will be displayed on the message bar.
To Next Page
Loading...
