- 82 -
6. Fit the duct to original position.
Place the humidifying tray and set the humidifying
tray cover as shown in Fig. 5.
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
7. Replace the insulations into the UV lamp lead wire
hole with the wires passed through the cuts on both
insulations. See Fig. 6.
㻌
UV lamp
lead wire
Insulation
Fig. 6
Fig. 5
Humidifying tray cover
8. Remote the 2 caps shown in Fig. 7.
Fit Glow Ass’y (䐢) and Ballast (䐣)
by using 4 screws (䐡).
䐡Screw (4pcs)
䐢Glow Ass’y
Cap
䐣Ballast
Fig. 7
To Next Page
Loading...
