Sanyo MCO-19M - Page 86

- 83 -
㻌
9. Connect each lead wire connectors of Ballast and Glow Ass’y as shown in Fig. 8
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
10. Labels layout
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
㻌
Fig. 9
䐧 UV door switch caution label
䐦 UV lamp caution label
䐨 Name plate
Put each label on the specified place. Use the name plate of MCO-19M(UV) for MCO-19M.
Connect them after
removing each cover
Ballast
White 3P
Red 2P
Blue 2P
White 2P
White 2P
UV lamp
White
White
CN14
white
Blue 1P
Green 1P
Yellow
Light blue
Noise filter
White 9P
Power trans.
Main PCB
Glow starter (FG-7P)
Fig. 8
䠄For MCO-19AIC/19M䠅
䠄For MCO-18AIC䠅
Glow starter (FG-7P)