Sanyo PDG-DHT8000L - Indicators and Projector Condition

-139-
Troubleshooting
Indicators and Projector Condition
Check the indicators for the projector condition.
The projector is operating normally.
• • • on
• • • off
• • • blinking at the normal rate
(approx. 1 second ON,
1 second OFF)
• • • dim
• • • blinking slow
(approx. 2 seconds ON, 2
seconds OFF)
• • • blinking fast (approx. 0.5
seconds ON, 0.5 sec-
onds OFF)
Indicators
Projector Condition
POWER
green
LAMP
red
WARNING
TEMP.
red
WARNING
FILTER
orange
SHUTTER
blue
LAMP 1/2
REP.
orange
j j j j j j
The projector is off. (The main On/Off switch is OFF
position or the AC power cord is unplugged.)
J J j
✽ ✽ ✽
The projector is in stand-by mode. Press the ON/
STAND-BY button to turn on the projector.
J j j
✽ ✽ ✽
The projector is operating normally.
(The Shutter is open)
J j j
✽
J
✽
The projector is operating normally.
(The Shutter is closed)
j J j
✽ ✽ ✽
The projector is preparing for stand-by or the projec-
tion lamp is being cooled down. The projector can-
not be turned on until cooling is completed and the
READY indicator lights green.
j j j
✽
j
✽
The projection lamp is being cooled down in the
Power management mode.
j j
✽
j
✽
The projector is in the Power management mode.
j j j
✽ ✽
The projection lamp is being cooled down in the
Shutter management mode.
J j j
✽
✽
The projector is in the Shutter management mode.
Press the ON/STAND-BY button to turn on the pro-
jector.
J j j
✽ ✽
The filter is scrolled using the FILTER button on the
remote control or the Filter control function in the set-
ting menu. When the filter is being scrolled, the Filter
replacement icon and “Please wait...” message (Fig.
1) appear on the screen.
Fig.1 Filter replacement icon and “Please wait...”
✽
• • • Differs according to conditions.
J
j
j