Sanyo PDG-DHT8000L - Ballast Assy Disassembly; Filter Duct Assy Disassembly

-34-
Mechanical Disassembly
(T3x25)x4
Fan guard
FN907
(T3x6)x2
(M3x6)
(T3x6)x2
(M3x6)
Spacer
Spacer
Ballast2 board
Ballast1 board
(T3x6)x4
(T3x6)x4
Spacer
Ballast board
Spacer location on the
ballast board
10-1 Ballast assy disassembly
10-2 Filter duct assy disassembly
(T4x8)x2
Filter shaft
holder
Filter motor
Filter sw
board
Round
board
(T3x8)x2
(T3x8)x3
Sensor
magnet
Holder filter
shaft mounting
Motor gear
Temp sensor
board
(T3x8)
(T3x8)
(T3x8)
Label side
FN903
(T3x12)
(T3x12)
(T3x8)
(T3x8)
FN908
Fan holder
Label side
(Bottom)
This fan does not
provide the fan holder
on this corner.
(T3x8)