Sanyo PDG-DHT8000L - Service Adjustment Menu Operation

-38-
To enter the service mode
To enter the “Service Mode”, press and hold the MENU and SELECT button for more than 3 seconds, or press
and hold the MENU button for more than 20 seconds.. The service menu appears on the screen as follows.
To adjust service data
Select the adjustment Group No. by pressing the MENU button (increase) or SELECT button (decrease), and
select the adjustment Item No. by pressing the pointer U or V button, and change the Data value by pressing the
W or X button. Refer to the “Service Adjustment Data Table” for further description of adjustment Group No., Item
No. and Data value.
To exit the service mode
To exit the service mode, press the ON/STAND-BY button.
Service Adjustment Menu Operation
Adjustments
Service Mode
Input Input 1
Image Standard
Group No. Data
0 0 32
Ver. 1.00
Data value
Item No.
Group No.
Firmware
Version No.