EasyManua.ls Logo

Sanyo PDG-DHT8000L - Page 147

Sanyo PDG-DHT8000L
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-147-
IC Pin Name Pin No. Signal Name Function I/O Operation
T17 362 - Not used -
R17 361 - Not used -
R16 402 - Not used -
U21 119 - Not used -
V21 120 - Not used -
W10 268 BALLAST_AC2 Ballast Power On/Off O H: On, L: Off
U10 370 BALLAST_AC1 Ballast Power On/Off O H: On, L: Off
V14 319 - Not used -
U14 366 BOOT_HOLD Writing Mode for Formatter Board O H: Normal, L: Write mode
U11 369 M_ASIC_READY DDP ASIC Startup Check I H:ASIC Not Start L:ASIC Start
U12 368 SCL_NIOS Not used I/O
V13 320 SDA_NIOS Not used I/O
V10 323 - Not used -
V11 322 - Not used -
U9 371 WP_CW1 CW ID Write Protect Mode Switch O H: Released L: Protected
V9 324 WP_CW2 CW ID Write Protect Mode Switch O H: Released L: Protected
V8 325 LAMP_STAT Lamp Status O H: Other, L: On
V12 321 INT Not used -
W7 271 PJ_MTR Not used -
V5 328 LENS_TEST Lens ID Write Protect O H: Released L: Protected
Control Port Functions

Table of Contents

Other manuals for Sanyo PDG-DHT8000L

Related product manuals