-7-
Anititheft Alarm Function Disable
This projector is equipped with an Antitheft alarm function which works when detecting a vibration to protect the pro-
jector from a suspicious person.
Release the alarm setting
Press the F button and input the four-digit PIN code within
10 seconds. (default PIN code "1111") When the alarm is
released, you will hear high-pitched confirmation sound.
When inputting an incorrect PIN code, you will hear low-
pitched sound. If you input incorrect PIN codes 3 times, the
alarm will start ringing.
Reset settings (Not in the Antitheft mode on)
If you forget the PIN code to setup the alarm setting, press
the button 3 and then press the F button twice. All the
settings you have made will go back to the factory default
settings. (default PIN code "1111")
Cancelling the Antitheft mode
If you forget the PIN code to release the alarm setting, press
and hold the button 3 and F button at the same time for
more than 3 seconds. The Antitheft mode will be off and all
the settings you have made will go back to the factory de-
fault settings. (default PIN code "1111")
Side Control
F button button 1, 2, 3
To Next Page
Loading...
Need help?
General
