Part Names and Functions
To ensure safe operation, please observe the following precautions :
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in compartment.
1
2
3
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5
m) and 60 degrees in front of the projector.
16.4'
(5 m)
30°
Remote control
30°
The 2 different remote control codes (Code 1–Code
2) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment next
to each other are operated at the same time. Change the
remote control code for the projector first before changing
that for the remote control. See "Remote control" in the
Setting Menu on page 52.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and
Code 2. The initial code is set to Code 1.
To Next Page
Loading...
Need help?
General
