65
– Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
– PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 19, 53-54.
– Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 52.
– Unlock the Key lock function for the remote control function.
See page 53.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 69.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at
under of SETTING section. See page 53.
– Contact the dealer where you purchased the projector or the service
center.
– The projector detects an abnormal condition. Unplug the AC power cord
and contact the dealer where you purchased the projector or the service
center.
appears on the screen
To Next Page
Loading...
