Sanyo SPW-C0705DXHN8 - Setting the Present Time

3-29
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
3. Timer Remote Controller
Setting the Present Time
1. Press and hold for more than 2 seconds to enter in the present
day and time setting mode.
Once you enter in the setting mode,
, “ ”(day) and “time” flash.
2. Set “
” to today’s day of the week.
Press *
1
to move “ ” (flashing on the display) in the order of :
Su Mo Tu .... Press to move it in the order of : Su St
Fr ....
*1
While in time setting mode, the temperature setting buttons function as
(changing day) button.
3. Press
to change the present “hour” in the range of 0 to 23*
2
.
Set the present hour and press
.
The “hour” digits light up, and the “minute” digits start flashing.
*2
If the clock uses the 12 hours AM/PM setting, the hour is displayed in the range of AM 0 to
11/PM 0 to 11.
4. Press
, to change the present “minute” in the range of 0 to 59.
Set the present minute and press
. The day and time are set and finishes the setting mode.
Note
• The unit returns to the normal mode if
is pressed or there is no operation made for 3 minutes
during the setting. In this case, all the settings in progress will be lost.
• If the present time is invalid, “– – : – –” is displayed.
If the power failure for more than 1 hour occurs, check if the set data of day and time are valid.
1,3,43,4 2