Sartorius arium mini plus - Setting the Date and Time

30 Operating Instructions arium
®
mini plus | arium
®
mini
Startup
6.4 arium
®
mini plus: Starting up the Device
When the system check is complete, the dialog box “Language” appears. The wizard
automatically performs all the startup steps. Startup takes approx. 120 minutes and
cannot be canceled.
All system settings (e.g. date, time, displayed values) that are made during the
startup can be changed afterwards in the “Settings” menu (see Chapter 7.3.3,
page 61).
Procedure
t Set the language (see Chapter 6.4.1, page 30).
t Start startup mode (see Chapter 6.4.2, page 30).
t Set date and time (see Chapter 6.4.3, page 31).
t Set the displayed values (see Chapter 6.4.4, page 32).
t Insert cartridges (see Chapter 6.4.5, page 32).
t Insert bag (see Chapter 6.4.6, page 34).
t Connect tubing to the rear of the device (see Chapter 6.4.7, page 37).
t Rinse ultrapure water cartridge (see Chapter 6.4.8, page 40).
t Connect final filter (see Chapter 6.4.9, page 42).
t Rinse final filter (see Chapter 6.4.10, page 42).
6.4.1 Setting the Language
Procedure
t Select the language for the display. The factory setting is English.
t Confirm the selection with the [l] button.
y The dialog box “Startup” appears.
Tip
The demo mode of the device can be started by tapping the [
DEMO] button. Access
to demo mode is password-protected and only accessible to Sartorius employees.
6.4.2 Starting Startup Mode
Procedure
t Tap the [w] button.
y The dialog box “Date and time” appears.
>
/DQJXDJH
(QJOLVK
'HXWVFK
)UDQoDLV
(VSDxRO
1
Startup
:HOFRPH<RXZLOOEHJXLGHGVWHSE\VWHS
WKURXJKWKHVWDUWXSSURFHGXUHRI\RXUQHZ
DULXPPLQL
DEMO
w
1
;
t
Date and time
)LUVWVHWXSWKHGDWHDQGWLPH