Sartorius arium mini plus - Setting the Date and Time

Operating Instructions arium
®
mini plus | arium
®
mini 43
Startup
6.5 arium
®
mini: Starting up the Device
When the system check is complete, the dialog box “Language” appears. The wizard
automatically performs all the startup steps. Startup takes approx. 120 minutes and
cannot be canceled.
All system settings (e.g. date, time, displayed values) that are made during the
startup can be changed afterwards in the “Settings” menu (see Chapter 7.3.3,
page 61).
Procedure
t Set the language (see Chapter 6.5.1, page 43).
t Start startup mode (see Chapter 6.5.2, page 43).
t Set date and time (see Chapter 6.5.5, page 45).
t Set the displayed values (see Chapter 6.5.5, page 45).
t Insert cartridges (see Chapter 6.5.5, page 45).
t Insert bag (see Chapter 6.5.6, page 47).
t Connect tubing to the rear of the device (see Chapter 6.5.7, page 50).
t Fill bag (see Chapter 6.4.8, page 40).
t Rinse ultrapure water cartridge (see Chapter 6.5.8, page 52).
t Connect final filter (see Chapter 6.5.10, page 54).
t Rinse final filter (see Chapter 6.5.11, page 55).
6.5.1
Setting the Language
Procedure
t Select the language for the display. The factory setting is English.
t Confirm the selection with the [l] button.
y The dialog box “Startup” appears.
Tip
The demo mode of the device can be started by pressing the [DEMO] button. Access
to demo mode is password-protected and only accessible to Sartorius employees.
6.5.2
Starting Startup Mode
Procedure
t Tap the [w] button.
y The dialog box “Date and time” appears.
>
/DQJXDJH
(QJOLVK
'HXWVFK
)UDQoDLV
(VSDxRO
1
Startup
:HOFRPH<RXZLOOEHJXLGHGVWHSE\VWHS
WKURXJKWKHVWDUWXSSURFHGXUHRI\RXUQHZ
DULXPPLQL
DEMO
w
1
;
t
Date and time
)LUVWVHWXSWKHGDWHDQGWLPH