18
3.3.10.4 User ID
This liquid handling device may be personalised by the user.
Personalising on software:
– Select menu
– Select User ID
– Press CLEAR - to clear the current ID or character
– Press the operating button, first character background turns white to
indicate that it is being edited. Available characters are alphabet in capital
and lowercase letters, numbers and symbols. Use middle soft key to change
the characters.
– To select the alphabet/number/symbol turn the adjustment wheel
– Press the operating button or OK to save the choice
– Press the operating button to move the cursor to the next character and
continue until the ID is completed.
– Press SAVE - the setting is saved
– Press BACK - the setting is not changed
NOTE! Clearing the current ID is not necessary, it can be overwritten.
3.3.10.5 GLP Info
GLP (Good Laboratory Practice) information indicates the date of the previous
service/calibration and when the next service/calibration is due.
– Select menu
– Select Setup
– Select GLP Info
– Turn the adjustment wheel to set the date of previous service and/or
calibration and press the operating button to move the cursor forward
– When the settings for the dates are set, press the operating button or OK to
save the settings
– Press BACK - the settings are not changed
NOTE! Picus will not remind the user of the next service and/or calibration.
3.3.10.6 Reset
Resetting the pipette will reset all the settings user has done to the factory
settings including programming in the memory places.
– Select menu
– Select Setup
– Select reset
– Pipette asks to set all the pipette settings to factory defaults:
Press the operating button or YES and tip ejection – the pipette will reset
the settings to the factory default
Press BACK - the settings are not changed
3.3.10.7 Information
Software version and battery charging level are shown in information menu.
Information menu cannot be edited by the user.
To Next Page
Loading...
Need help?
General
