Sartorius FB - Operating the Scale: Additional Functions and Examples; Weight ID, Calibration, Setup, Power Off, and Weighing Examples

24
ID for weight value (if desired):
● Select the parameters
“Line format” and “For other
app./GLP/GMP” from the
Setup menu: Press M
● Select mode:
Press the menu soft key
● Set parameter 7 2 2: see the
chapter entitled “Configuring the
Scale”
● Exit the Setup menu:
Press M
Additional Functions
In addition to the functions:
– alphanumeric input,
– taring
(not during alphanumeric input),
– printing,
you can also access
the following functions from the
weighing application:
– calibration
(not for alphanumeric input),
– setup,
– turning off the scale.
Calibration
● Press [ISOTEST]/[TEST]
> See the section on “Calibration/
Adjustment” for further instructions.
Setup Menu
● Press M
> See the chapter entitled
“Configuring the Scale” for
further instructions.
Turning Off the Scale
● Press e/[ON/OFF]
> The scale shuts off
> The display goes blank
Practical Examples
Example W1: Simple Weighing
Step Key (or instruction) Display/Output
1. If necessary, tare the scale t
(U symbol: scale is tared,
– verified scales only)
2. Enter sample ID see Example W2
3. Determine sample weight Place sample on scale
(Example)
4. Print weight p/[PRINT]