55
Operating the Scale
Practical Example
When weighing in formulation components, the second component is over-poured.
(Parameter settings: Recalculation application: 2 1 9; Print all parameters: 7 1 2)
Step Key (or instruction) Display/Output
—————————————————————————————————————————————————
1. Select the recalculation see “Preparation”
application in the Setup menu
2. Place container for filling Place empty container
components on the scale on the scale
3. Tare t
4. Add the first component Weigh the first component
into the container
5. Store component Press the comp.1
soft key (v/[FUNCTION])
6. Add the second component Weigh the second
component into the container
7. Start recalculation, because recal
12.42 g were poured rather soft key [ISOTEST/TEST]
than 12.30 g
8. Either press the minus minus soft key repeatedly
key to correct the value...
store comp.1
store comp.1
store comp.1
recal. add. comp.2
minus plus comp.2
minus plus comp.2
Comp1 + 27.08 g
To Next Page
Loading...
