6
Mounting the Display and Control Unit
You can mount the display and control unit in one of 3 ways:
– on the column, which is then fastened to the back of the scale
– on the retainer, which is then fastened to the front of the scale
– on the retainer separately from the scale
Mounting the Control Unit and Column
FB06BBE-S, FB6CCE-H, FB2CCE-S, FB12CCE-S, FB6CCE-S, FB12CCE-I
● Use the two Phillips head screws supplied to fasten the display and control
unit to the column
● Attach the column to the scale using the screw supplied
● Fasten the connecting cable to the column using the two clips, and slide
the cable into the cable channel under the scale
To Next Page