7
Getting Started
Fastening the Display and Control Unit to the Front
of the Weighing Platform or Mounting it Separately
● Turn the scale over and place it on a cushioned surface to prevent
damage to the weighing system
● Fasten the retainer to the display and control unit using the two Phillips
head screws 1 (M4x12)
● Fastening the display and control unit to the weighing platform:
Fasten the retainer with the two Phillips head screws 2 (M4x12) to the
weighing platform
● Press the cable into the raceway (channel) as shown in the diagram
on the left
> Cable length: 55 cm (approx. 21.7 inches)
k To order a longer cable, see the section entitled “Accessories”
FBG34EDE-H, FBG34EDE-P, FBG16EDE-H, FBG12EDE-P, FBG64EDE-S,
FBG64EDE-H
● Use the two Phillips head screws (M 4x8) supplied to fasten the display
and control unit to the column
● Attach the column to the scale using the screw (M 4x20) supplied
● Fasten the connecting cable to the column using the three clips
To Next Page
Loading...
