19
Counter
Counter counts the number of pipetting cycles up to 384 and can be used
in conjunction with Pipetting and Reverse Pipetting modes. You can start
counting from any number up to 384. The starting number can be set with
the adjustment wheel directly after the advanced function has been activated,
or using the EDIT function in the main mode.
Mixing
With the Mixing mode the pipette mixes the liquids either manually when the
operating button is held down or automatically a set number of times. The
Mixing mode can be used in conjunction with Pipetting and Diluting modes.
The volume for mixing can be selected freely up to the maximum volume of
the pipette.
To edit the volume settings and select manual or automatic:
1. Select Mixing mode. The display shows the volume used for mixing (80%
of the volume to be dispensed).
2. Turn the adjustment wheel to set the desired volume for mixing.
3. Confirm the setting by pressing either:
a. the operating button or the right Softkey for OK. This also exits the
editing mode.
OR
b. the middle Softkey for NEXT, to move on to select manual or automatic
mixing and the number of mixing cycles.
4. If you chose 3.b, either turn the adjustment wheel to select Manual or
choose the number of automatic dispensings.
5. Confirm the setting by pressing the operating button or the right Softkey
for OK, which will also exit the editing mode.
To activate/deactivate mixing:
1. Start your chosen main mode and when the display tells you to “Start
mixing”, either:
a. press and hold down the operating button for the duration of manual
mixing.
OR
b. press the operating button once to activate the automatic dispensing
cycles.
OR
c. press the left Sofkey for NO to exit Mixing.
2. You may pause mixing by pressing the operating button during the mixing
cycle. By pressing it again, mixing continues.
3. You may also exit mixing during the mixing cycle by pressing the left
Softkey for QUIT.
4. Continue by emptying the tip.
Excess Adjustment
Excess Adjustment can be used to set the excess volume in Reverse Pipetting,
Multi-Dispensing, and Sequential Dispensing modes, where excess volume is
being used. The excess volume varies according to the volume range of the
pipette.
To set the excess volume:
1. Turn the adjustment wheel to select the desired volume after the
advanced function has been activated. You may also press the middle
Softkey for DEFAULT to choose the default excess volume.
2. Confirm the selection by pressing the operating button or the right
Softkey for OK.
To Next Page
Loading...
Need help?
General
