2.2 Installation Instructions
Do not operate the balance if its housing or AC
adaptor is damaged. Immediately disconnect the
damaged device from the power by pulling the plug.
Do not expose the balance, its AC adaptor or
the accessories supplied by Sartorius to extreme
temperatures, aggressive chemical vapors, moisture,
shocks, vibrations or strong electromagnetic fields.
Observe the conditions of operation described in the
“Technical Data”!
The operator shall be solely responsible for any
modifications to the equipment and for connecting
any cables or equipment not supplied by Sartorius!
Information on operational quality is available upon
request from Sartorius.
You should only use peripherals supplied by
Sartorius!
Note the IP protection class of the balance and its
AC adaptor! Do not allow liquid penetration.
The protection class specifies the suitability of
equipment for various environmental conditions
(moisture, foreign bodies).
Before cleaning the AC adaptor or the balance:
Unplug from the mains power.
The balance may only be opened by specialized
personnel trained by Sartorius. Do not open the AC
adaptor.
Warnings at the Place of Installation and During Operation:
If glass breaks, there is a risk of injury posed by cuts
on glass edges.
Lay the cables where they pose no risk of causing
someone to trip.
Observe the additional safety and danger information in the
following chapters.
2.3 Intended Use
This high-resolution balance is exclusively for use in laboratories
and indoors under normal atmospheric conditions. It was developed
specifically for the exact determination of the mass of materials in
liquid, paste, powder or solid form.
Appropriate containers must be used for each type of sample
material.
3. Getting Started
The balance must be disconnected from the mains
power for all assembly work.
3.1 Unpacking and Equipment Supplied
t Open the packaging, making sure to remove of all parts carefully.
t After unpacking the device, check it immediately for any external
damage.
y If you detect any damage, proceed as directed in the “Care and
Maintenance” chapter.
y Save all parts of the original packaging for any future
transportation. During shipment, please do not leave cables
plugged in!
The following parts are included in the equipment supplied:
Components Secura
®
Quintix
®
Model 26 225D
125
324 125D
65
35
Draft shield (4 panels) x x x x x
Collection container x x x x x
Weighing pan: d 80 mm
x – x x
Weighing pan: d 90 mm
– * x * *
Weighing pan: d 50 mm
x – – – –
Shield disk (normal / high) x – – – –
AC adaptor with country-
specific power plug
x x x x x
In-use dust cover x x x x x
Dust cover x x x x x
Installation and
Operating Instructions
x x x x x
Application guide
x x x x x
* Optional
3.2 Installing the Balance
Collection Container Installation
t Insert the collection container into
the balance.
Assembling the Panels
t Press against the front of the cover
from both sides and fold it upwards.
t Inserting the front panel of the draft
shield:
− Insert the panel on the top into
the guide rails of the draft shield.
− Press the panel gently upwards,
while simultaneously pressing
downwards into the slot of the
draft shield.
− The panel must latch into the slot.
4 Installation and Operating Instructions Manual Secura
®
, Quintix
®
To Next Page
Loading...
