Sartorius Secura Quintix 26 - 4 Transporting the Balance; 5 Shipping the Balance

4. Transporting the Balance
Before moving the balance, switch it to the standby mode, then
unplug the power connector and remove the weighing pan from
the balance.
Moving the Balance over Short Distances in the Lab
Avoid glass breakage,
shocks and vibrations:
Never lift or carry the
balance by its draft
shield!
t Hold the balance under the
housing, lift it up carefully and
carry it to its new location.
The balance needs to
be re-leveled and then
adjusted each time
its setup location is
changed.
5. Shipping the Balance
Prior to shipping, switch the balance to standby
mode (see 8) and then pull the plug.
Please use the original packaging for shipping.
Packaging can be ordered through the Sartorius
Service Center if required.
Detaching the Draft Shield / Weighing Pan
Danger of damage to
the side panels!
The guide carriages
of the side panels are
provided with fine steel
filaments.
Removal of these steel
filaments or carrying
out any other modi-
fications to the guide
carriages is forbidden.
t Press against the front of the cover
from both sides and fold it upwards.
t Push the upper panel forwards and
pull it out of the draft shield.
t Push the side panels slightly
backwards and remove them from the
draft shield.
t Pull the front panel over the groove of
the draft shield and remove the panel.
t Pull the front panel over the groove
on the bottom of the draft shield and
remove the panel.
t Pull the weighing pan out of the
collection container.
t Remove the collection container.
Secura
®
26
t Pull the weighing pan out of the
collection container.
t Take the shield disk off the collection
container.
t Lift out the collection container.
Packing the Balance
t Insert the bottom part of the
packaging into the box.
t Place the balance in the bottom part
of the packaging.
t Place the remaining components of
the balance into the recesses provided
in the packaging part:
− Collection container
− Weighing pan
− Right and left side panels
− Top panel
− Front panel
− Shield disks (Secura
®
26 only)
t Close the cardboard with the
components and the corresponding
packaging part.
t Place the cardboard in the recess
provided for the purpose.
t Put the top part of the packaging over
the device parts.
t Next, put the packaged balance into
the cardboard box and seal the box.
Installation and Operating Instructions Manual Secura
®
, Quintix
®
7
English