3
Getting Started
Storage and Shipping Conditions
– Do not expose the balance/scale to
extreme temperatures, blows, shocks,
vibration or moisture.
Unpacking the Balance/Scale
After unpacking the balance/scale,
check it immediately for any visible
damage
$ If you see any sign of damage, proceed
as directed in the chapter entitled “Care
and Maintenance,” under the section on
“Safety Inspection”
$ Save the box and all parts of the
packaging until you have successfully
installed your balance/scale in case you
need to return it. Before packing your
balance/scale, unplug all connected
cables to prevent damage.
Equipment Supplied
– Balance/scale
– Weighing pan
– Pan support (only on models with
a round weighing pan)
– Gem tray (only with GE and GD models)
– AC adapter, plug type
Additionally supplied with AZ214,
AZ124, AZ64, TE214S, TE124S, TE64,
GD603, GD103, GD502-DS models:
– Shield ring
– Shield plate
– Dust cover
Additionally supplied with
TE313S-DS, TE153S-DS models:
– Draft shield chamber with sliding doors
Additionally supplied with
TE313S, TE153S, GD252 models:
– Glass draft shield with cover
Additionally supplied with
GD252-DS, GD502-DS models:
– Draft shield chamber with sliding doors
– 50-g calibration weight (F1)
Installation Instructions
When choosing a location to set up your
balance/scale, observe the following:
– Avoid placing the balance/scale in
close proximity to a heater or otherwise
exposing the balance/scale to heat or
direct sunlight
– Protect the balance/scale from drafts
that come from open windows or doors
– Avoid exposing the balance/scale to
extreme vibrations during weighing
– Do not expose the balance/scale to
extreme moisture over long periods
Conditioning the Balance/Scale
Moisture in the air can condense on the
surfaces of a cold balance/scale whenever
it is brought into a substantially warmer
place.
If you transfer the balance/scale to
a warmer area, make sure to condition it
for about 2 hours at room temperature,
leaving it unplugged from AC power.
To Next Page
Loading...
