Sartorius talent - Setting up the Balance;Scale; Draft Shield and Weighing Pan Assembly

4
Setting up the Balance/Scale
Balances/scales with a draft shield chamber with
sliding doors
 Place the components listed below inside
the chamber in the order given:
– Shield plate
– Shield ring (not for models TE313S-DS, TE153S-DS)
– Pan support
– Weighing pan
– Gem tray (only with GD models)
Balances/Scales with a Glass Draft Shield
 Place the components listed below inside
the chamber in the order given:
– Draft shield base – place it on the balance/scale
so that the edge for fitting the glass draft shield
faces upwards and turn it until it is firmly in place
– Pan support
– Weighing pan
– Glass draft shield
– Gem tray (only with GD models)
– Draft shield cover – place it on the balance/scale
so that the edge faces downwards
Balances/Scales with a Round Weighing Pan
 Place the components listed below inside
the chamber in the order given:
– Pan support
– Weighing pan
– Gem tray (only with GE models)
Balances/Scales with a Rectangular Weighing Pan
 Place the weighing pan on the balance/scale
 Gem tray (only with GE models)