Satel ACU-280 - User Manual

To Next Page

ABAX 2 wireless system controller

ACU-280

Firmware version 6.06

acu-280_en 03/23

SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND

tel. +48 58 320 94 00

www.satel.pl

Main Page

Table of Contents4
Introduction7
Features7
Electronics Board8
Terminals8
DIP-Switches9
Selecting the Controller Operating Mode9
Address Setting [Controller in the INTEGRA System]9
Enabling / Disabling the Support of the Unregistered ARF-200 Tester10
RS-485 Bus [Module of Wireless Devices with Modbus RTU Interface]10
Table of Modbus RTU Protocol Registers10
Installation of the Controller13
Selecting a Mounting Location13
Preparing the Cabling13
Installation of Enclosure13
Setting DIP Switches15
Connecting the Wires15
Expander of Wireless Devices for SATEL Alarm Control Panels15
Module of Wireless Devices with Modbus RTU Interface17
Powering on and Starting the Controller17
ABAX 2 Soft Program17
Description of the Program18
Menu Bar in the Program18
Additional Menu18
Establishing Connection between the Program and the Controller19
Configuration19
Devices21
Status22
Graphs24
Comm. History24
Keyfobs26
Keyfob State26
Wireless Devices Supported by the Controller27
Devices27
Keypads28
Keyfob28
Installation of ABAX 2 Wireless Devices28
Registering Devices to the Controller29
Expander for the INTEGRA Series Control Panels29
Adding New Wireless Devices31
Removing Wireless Devices33
Expander for the PERFECTA 64 M Control Panel34
Adding New Wireless Devices35
Removing Wireless Devices37
Expander for VERSA Series Control Panels37
Adding New Wireless Devices37
Removing Wireless Devices39
Module of Wireless Devices with Modbus RTU Interface39
Adding New Wireless Devices40
Removing Wireless Devices40
Programming the ABAX 2 System41
Expander for the INTEGRA / VERSA Series Control Panels41
Controller Settings41
Functions43
Device Settings43
Programming Devices Using the DLOADX Program45
Programming Devices Using the LCD Keypad49
Specific Character of the Operation of Wireless Devices53
Wireless Detectors53
Wireless Sirens53
Wireless Expanders of Hardwired Zones and Outputs54
Smart Plug / Wireless 230 VAC Controller54
Wireless Radiator Thermostat54
Radio Signal Repeater55
Expander for the PERFECTA 64 M Control Panel55
Controller Settings55
Wireless Devices56
Programming Devices in the PERFECTA Soft Program57
Specific Character of the Wireless Devices Operation60
Wireless Detectors61
Wireless Sirens61
Wireless Expanders of Hardwired Zones and Outputs62
Smart Plug / 230 VAC Wireless Controller62
Wireless Radiator Thermostat63
Radio Signal Repeater63
Module of Wireless Devices with Modbus RTU Interface63
Programming Devices Using the ABAX 2 Soft Program63
Specific Character of the Operation of Wireless Devices66
Wireless Detectors66
Wireless Sirens67
Wireless Expanders of Hardwired Zones and Outputs67
Smart Plug / Wireless 230 VAC Controller68
Wireless Radiator Thermostat68
Radio Signal Repeater68
APT-200 Keyfobs68
Expander of Wireless Devices for SATEL Alarm Control Panels69
Keyfobs in the INTEGRA System69
Keyfob Management Using the DLOADX Program70
Keyfobs in the PERFECTA 64 M System71
Keyfob Management Using the PERFECTA Soft Program71
Keyfobs in the VERSA System73
Keyfob Management Using the DLOADX Program73
Module of Wireless Devices with Modbus RTU Interface75
Keyfob Management75
Adding a Keyfob75
Removing a Keyfob75
Controller Firmware Update75
Updating the Firmware of ABAX 2 Wireless Devices76
Restoring the Controller Factory Settings76

Need help?

Do you have a question about the Satel ACU-280 and is the answer not in the manual?

Satel ACU-280 Specifications

General

Power supply voltage	12 V DC
Operating temperature range	-10°C to +55°C
Communication interfaces	RS-485
Supported protocols	Satel
Radio frequency band	868.0 ÷ 868.6 MHz

Related product manuals

Satel ACU-280 - User Manual

Table of Contents

Satel ACU-280 Specifications

Related product manuals