SATEL ACU-280 71
4. Click the „Write” button to write the changes to the controller.
Removing a keyfob
1. Click the field in the “Serial number” column next to the name of the user from whom you
want to remove the keyfob.
2. Click . The “Device deleting” window will be displayed.
3. Click “Delete”. The “Device deleting” window will close.
4. Click the „Write” button to write the changes to the controller.
Default keyfob settings
You can configure the default keyfob settings (assign functions to buttons / define operating
mode of LEDs). This makes it easier to add keyfobs because each new keyfob will be
automatically configured based on the default settings. The settings of each keyfob can be
later customized to the user needs and rights.
Changing the default functions has no effect on the settings of keyfobs which are
already added to the users.
9.1.3 Keyfobs in the VERSA system
The functions which can be started using the keyfobs and the information that can be
presented on the LEDs are described in manuals for the VERSA series control panels.
After a keyfob has been added, its settings will be configured automatically, based on the
user schedule. These settings can be modified (different functions can be assigned to the
buttons / combination of buttons and different information to the LEDs).
The user manual for VERSA series control panels describes the procedures for adding and
editing the user by means of the keypad, during which you can add or remove the keyfob and
program its settings.
Removing a keyfob only clears its serial number, but not its settings. If a new keyfob is
added to the user, it will have the same settings as the removed one.
You can remove all keyfobs, including their settings, by means of the “Rem.ABAX
kfbs” function available in the service mode in the keypad (“2.Hardware” “1.Kpds.
& exps.” “8.Rem.ABAX kfbs”).
9.1.3.1 Keyfob management using the DLOADX program
You can add and delete keyfobs in the “Versa – Structure” window, “Hardware” tab, after
clicking the controller name in the list of devices, and then on the “Keyfobs” tab (Fig. 30).
Before making any changes, click the “Read” button, and after making the changes – the
“Write” button (the data relating to keyfobs are not read after clicking the button or
saved after clicking the button in the DLOADX program main menu).
To Next Page
