38 ACU-280 SATEL
7.1.4.1 Adding new wireless devices
You can add a wireless device in the “Devices” tab.
1. Click . Data on wireless devices will be read from the controller.
2. Click .
3. The “Adding devices” window will be displayed.
4. In the “Serial number” field, enter the serial number of the device to be added.
5. Power on the device (install the battery in the device, turn on the device power, etc.).
6. A message will confirm that the device has been added (unless you have entered an
invalid serial number, of which the message will inform you).
6.1. Device type will be displayed. For the AXD-200 multipurpose detector, you can select
the device type.
If the device type you select is different from the type set before the AXD-200
detector was added to the system, the type will change during the periodical
communication. It results in a delay whose duration depends on the frequency of
periodical communication (with the “ECO” option enabled, delay can be up to
3 minutes).
6.2. The device name will be displayed. You can change that name. If the device
occupies two or more positions on the device list, the name will be repeated in all
positions.
6.3. For some devices you can select if the device is to occupy one or two positions on
the list of devices.
6.4. You can select which position(s) the device is to occupy on the list of devices.
7. Click .
8. The “Adding devices” window will close.
9. The new device will be displayed on the list of devices.
10. Click . The new device data will be written to the controller.
7.1.4.2 Removing wireless devices
You can remove a wireless device in the “Devices” tab.
1. Click . Data on wireless devices will be read from the controller.
2. Click the device you want to remove (if the device occupies two or more positions on the
list, you can click any of them).
3. Click .
4. The “Device deleting” window will open.
5. Click the “DELETE” button.
6. The “Device deleting” window will close.
7. Click . The device data will be deleted from the controller.
To Next Page
