Satel ACU-280 - Programming Devices Using the DLOADX Program

SATEL ACU-280 43
 temperature,
 tolerance.
ATX-230 – hardwired zone expander: NC and roller shutter. You can configure parameters
of roller shutter input [second zone]:
 number of pulses after which the roller shutter input will generate alarm,
 time period during which the defined number of pulses must occur for the roller
shutter input to generate alarm.
AVD-100 (AVD-200) – wireless shock detector and magnetic contact:
 do not configure the magnetic contact settings [first zone] (the AVD-200 detector
does not have two reed switches).
 for the shock detector [second zone]:
− you can configure sensitivity (registering a shock meeting the sensitivity criterion
will generate alarm),
− do not configure the number of shocks (the AVD-200 detector does not count up
the shocks).
ASP-100 (ASP-200) – wireless outdoor siren. You can configure:
 type of acoustic signaling,
 maximum duration of signaling.
ASP-205 (ASP-215) – wireless indoor siren. You can configure the signaling parameters
for both positions occupied by the siren (which enables two different types of signaling
to be programmed):
 maximum duration of signaling,
 type of acoustic signaling,
 optical signaling option.
ASW-100 (ASW-200) – 230 VAC smart plug. You can select operating mode.
ASW-210 – flush-mounted wireless two-channel 230 VAC controller. You can select the
operating mode of the controller inputs.
Filter [Filter] – the number of consecutive communication periods without connection
between the device and the controller after which loss of communication with the device
will be reported. You can enter values from 0 to 50. Entering 0 disables the check for
device presence in the system.
Temp. corr. – you can correct the temperature information sent by the device by up to
±3.5°C.
ECO – if this option is enabled, periodical communication with the device takes place every
3 minutes. Thus the battery life can be extended up to four times.
Remember that with the “ECO” option enabled for:
detectors – delay between arming / disarming and changing the detector operating
mode (active / passive) can be up to three minutes,
ASP-215 siren – delay in starting / stopping the signaling can be up to three minutes.
8.1.3.1 Programming devices using the DLOADX program
Before making any changes, click the “Read” button, and after making the changes – the
“Write” button. The data on wireless devices are not read / written when you use buttons in
the DLOADX main menu.
ARU
In the “ARU” column:
• leave the field blank, if the device is to communicate directly to the controller,