44 ACU-280 SATEL
• enter the ARU-200 repeater number in the list of wireless devices, if the device is to
communicate to the controller via the repeater (the repeater takes up two positions on the
list of devices – enter the number of the first of them).
Configuration
In the “Configuration” column you can configure additional settings for the ABAX 2 devices.
ACD-220
Enter a digit from the 1 to 3 range to set the sensitivity (1 – low, 2 – medium, 3 – high).
ADD-200
Dusk sensor – enter a number from the 1 to 16 range to determine sensitivity (1 – minimum;
16 – maximum).
Temperature sensor – enter in turn:
• letter H (high temperature threshold) or L (low temperature threshold),
• number from a range of -30 to +70 (with 0.5 accuracy) to define temperature,
• number from a range of 0.5 to 10 (with 0.5 accuracy) to define tolerance.
AGD-100 (AGD-200)
Enter a digit from the 1 to 3 range to set the sensitivity (1 – low, 2 – medium, 3 – high).
AMD-100 (AMD-200) / AMD-101 (AMD-201)
Do not configure.
AMD-102 (AMD-202)
Magnetic contact – do not configure.
Roller shutter input – enter 2 digits:
1st digit – number of pulses: from 1 to 8.
2nd digit – counting time: 0 (30 seconds), 1 (120 seconds), 2 (240 seconds) or 3 (unlimited
time).
AOCD-250 (AOCD-260)
Enter 2 digits:
1st digit – sensitivity of PIR sensor: from 1 to 4 (1 – minimum; 4 – maximum).
2nd digit – sensitivity of microwave sensor: from 1 to 8 (1 – minimum; 8 – maximum).
AOD-200 (AOD-210)
Enter 3 digits:
1st digit – sensitivity of PIR sensor: from 1 to 4 (1 – minimum; 4 – maximum).
2nd digit – sensitivity of microwave sensor: from 1 to 8 (1 – minimum; 8 – maximum).
3rd digit – sensitivity of dusk sensor: from 1 to 4 (1 – minimum; 4 – maximum).
APD-100 (APD-200)
Enter a digit from the 1 to 3 range to set the sensitivity (1 – low, 2 – medium, 3 – high).
APD-100 (APD-200 Pet)
Enter 2 digits:
1st digit – sensitivity: 1 (low), 2 (medium) or 3 (high),
2nd digit – pet immunity option – 0 or 1 (the entered value is irrelevant).
To Next Page
