SATEL ACU-280 31
To the outputs, the device is assigned automatically (to the first unoccupied outputs from the
pool reserved for the controller).
1. Start the “New device” function.
2. When the “Device serial number:” is displayed, enter the serial number of the device
being added.
3. Press .
4. When the “Open device tamper” command is displayed, power on the device (insert the
battery into the device, turn on the device power, etc.).
5. Type and serial number of the device will be displayed (if a message is displayed instead
to inform you that the entered serial number is invalid or the device is already registered,
press to quit the function).
6. Press the key 1.
7. If you can select whether the device will take up one or two positions (channels) on the list
of devices, a special message will inform you about it. Press the key 1 (the device will
occupy 1 position) or the key 2 (the device will occupy 2 positions).
8. Use the and keys to select the zone to which you want to assign the device.
9. Press .
10. A message will be displayed to inform you that expander identification procedure has
been started.
11. When the procedure is finished, the new name of the zone / output to which the device
has been assigned will be displayed. You can change that name.
12. Press .
13. If the device occupies two or more zones / outputs, the name giving procedure is
repeated for them.
7.1.1.2 Removing wireless devices
DLOADX program
You can remove a wireless device in the “Structure” window, “Hardware” tab, after clicking
the name of the controller on the device list, and then on the “Zones/Outputs” tab.
1. Click the “Read” button. The data related to wireless devices will be read from the
controller (these data are not read after clicking the button in the main menu).
2. Click the device you want to remove (if the device occupies two or more positions on the
list, you can click any of them).
3. Click the “Remove device” button.
4. The “Confirm” window will open.
5. Click the “Yes” button.
6. The “Confirm” window will close.
7. Click the “identification” button. The wireless zones / outputs will not be removed from the
alarm system until the expander identification procedure is finished.
LCD keypad
You can remove a wireless device in the service mode, using the “Remove device” function
(“Structure” “Hardware” “Expanders” “Settings” [controller name] “Remove
device”).
1. Start the “Remove device” function.
2. List of wireless zones will be displayed.
To Next Page
