Satel CA-10 - Quick arming; Disarming and clearing alarm

CA-10 SATEL
9
The panel may fail to arm the system if:
•
the panel is not ready for arming
: there are specifically selected zones which
cannot be violated when the system is being armed and one of them is violated at
the time of arming - the panel will signal the situation with three long beeps. In
such a case, it is recommended to wait until all the zones are ready (the LEDs 1-
12 / 1-16 go out), and then arm the system again. If one of the zones remains
violated (one of the LEDs 1-12 / 1-16 is on, which may be caused e.g. by
a detector trouble) the armed mode can be activated after bypassing that zone
(with function 4),
•
the access code is wrong
- the control panel will signal the event with two long
beeps
•
the partition contains no armed type zones
- the control panel signals the event
with two long beeps (access code is correct and allows, for example, to call user
functions)
•
battery trouble
- three long beeps (proper option is selected to prevent the
system from being armed in case of battery trouble).
Quick arming [0][#]
The user can quickly arm the system without any access code by pressing the [0][#] key
sequence. The Quick Arming function can be disabled by the installer. This way of
arming is not affected by any detectors being violated at the time. The installer can also
install a special key for quick arming of the system.
Disarming and clearing alarm [CODE][#]
When the control panel is armed (ARMED / PARTITION LED is on or blinking) or
signals an alarm (ALARM LED is blinking), it can accept only one command: disarming
the system or clearing the alarm. Entering the access code confirmed by pressing the
keys [#] will disarm the system or turn the alarm off. If, when entering the access code,
the user makes a mistake, he should press the [
*
] button and re-enter the code.
The panel confirms acceptance of the command by three short beeps and extinguishing
the ALARM and ARMED (PARTITION) LEDs.
The control panel will not disarm the system or clear the alarm if:
•
the access code is invalid,
•
the access code authority level does not allow disarming (for example, authority
level 3 or 9 - see "User Functions" - "User add")
It is also possible to clear the alarm without disarming the system by using the authority
level 0 access code.
In the LCD keypad disarming the system is confirmed with an appropriate message on
the LCD display and the name of the user who armed the system. If the alarm has been
cleared the keypad will display the message "View (
ÇÈÅÆ
)" - the arrow buttons allow
viewing partition status to find out the source of alarm.
If the alarm system is divided into partitions, the alarm can only be cleared in the
partition whose keypad signals the alarm condition with the ALARM LED.