Satel CA-10 - User functions; Switching CHIME on;off; Keypad backlighting; Fire alarm

CA-10 SATEL
15
12 - output 4 trouble
ALL OFF - system memory error
- the message appears in case of erratic
microchip operation of the system (it may be caused by strong
electromagnetic interference e.g. produced by lightning) - in most cases
service should be called.
Pressing any key stops the function. If the installer has enabled the audible trouble
signaling, activating the trouble check-out function turns the signaling off.
Switching CHIME on/off [8]
The function makes it possible for the user to switch the chime (audible signaling of the
violation of specified detectors) on/off in the keypad. Three short beeps in the keypad
confirm switching off of the chime signaling. Four short and one long beeps confirm
switching the chime on.
The installer decides which zones and in which keypads can use chime to signal their
status.
Keypad backlighting [9]
The function, which is only available in the CA-10 KLED-M and CA-10 KLED-S keypads
irrespective of the installer's settings, is used to control the keypad backlighting.
After restarting the system (power-up), the keypad always enters the automatic
backlighting mode, which is activated by pressing any key. To change the backlighting
mode, press the numeric key 9 and hold it down until you hear the corresponding signal.
One
beep -
no
backlighting.
Two
beeps -
automatic
backlighting.
Three
beeps -
continuous
backlighting.
Fire alarm [
*
]
This function activates the fire alarm from the keypad.
Auxiliary alarm [0]
The purpose of this alarm depends on current needs. It may be, for instance, an
emergency call for medical assistance. The function may transmit an appropriate
message about auxiliary alarm to the monitoring station and activate telephone
messaging.
Panic alarm [#]
This function activates the panic alarm from the keypad.
The functions of keypad alarms may be disabled by the installer.
User functions
If the control panel is disarmed and is signaling no alarm, there are some functions,
useful in everyday operation of the alarm system, available to the users. The access to
specific functions depends on the user's authority level.