Satel CA-10 - User access code change; User (code) add; User (code) erase

USER MANUAL CA-10
16
In order to get access to the user functions, enter the user access code and
confirm it with the [
*
] key
(not the [#] key, as is the case with arming / disarming). The
LEDs ALARM, ARMED (PARTITION), TROUBLE will start blinking in the keypad.
To
start a specific function, you must
first enter and confirm the user code
and then
press the key with the function number
:
•
user access code change [code][
*
][1]
•
user (code) add [code][
*
][2]
•
user (code) erase [code][
*
][3]
•
zones bypass [code][
*
][4]
•
silent arming [code][
*
][5]
•
time setting [code][
*
][6]
•
MONO switch outputs activate [code][
*
][7]
•
BI switch outputs activate [code][
*
][8]
•
power supply reset (on „RESET power supply” outputs) [code][
*
][9]
•
telephone DOWNLOADING start [code][
*
][0]
Notes:
•
The functions [CODE][
*
][2] and [CODE][
*
][3] are only available to the partition master
code user.
•
The functions [CODE][
*
][7] and [CODE][
*
][8] are always available, irrespective of
whether the control panel is armed, or not.
In the LCD keypad
, after entering the user code and confirming it with the [
*
] key, the
list of user available functions will be displayed.
User access code change [CODE][
*
][1]
This function enables changing the access code of the user by whom it was activated.
Having called the function, enter a new code and confirm it by pressing the [#] key. The
keypad will confirm the code change by a sequence of beeps (the LCD keypad will
display the name of the user, whose code has been changed).
The function is available to the master user and users with authority level 1, 2 or 7.
Æ
Change own code
Add user
the arrow points to the
function that will be
activated by pressing
[#] or
► key
list of functions:
1. Change own code
2. Add user
3. Erase user
4. Bypass zones
5. Arming silent
6. Set time
7. Mono outs active
8. Bi outs switch
9. Supply reset
0. Tel. DWNL start
View events