Satel CA-10 - Functions of ◄►▲▼ Key in the LCD Keypads; Find the partition where alarm was activated; Find the violated zones; Find the zones that caused the alarm

CA-10 SATEL
11
Functions of
◄▲▼►
Key in the LCD Keypads
Activated by installer functions assigned to
◄▲▼►
keys help in everyday control of
the system operation. The function is called by pressing the corresponding key. The
installer can disable the functions described below.
Find the partition where alarm was activated
S
key
In multi-partition systems the find function enables determining the partition where alarm
was activated. On calling, the function shows by means of ARMED (PARTITION) LEDs
the partitions where alarm was activated, and on the LCD display the names of
partitions (every time the
S
key is pressed next partition name is shown).
Find the violated zones
W
key
The function displays the names of violated zones. The zones are shown on pressing
the
W
key (the function shows the partition zones as selected by the installer).
Find the zones that caused the alarm
X
key
The function displays the zone names for which the alarm has not yet been cleared
(individual alarm memory for zones). Every time the
X
key is pressed next zone name
is shown.
Find the partition where the keypad is attached
T
key
The function displays the name of the basic partition operated with a keypad (the
partition to which the keypad is physically attached).
Changing display mode of system state
T
key
Pressing and holding down the
T
key for about 3 seconds will temporarily change the
operating mode of LCD keypad: instead of displaying text messages on the system
status it will display the state of armed zones in LCD standard (and vice versa). The
keypad will automatically return to the operating mode specified by the installer after 40
or 140 seconds since the last key was pressed (depending on how the „long backlight”
option is set).
„HOLD DOWN” User Functions
The functions are available to any user (without using the access code). They are
activated by holding down the function key for about 3 seconds.
Switching to n partition (GOTO n) [1][2][3][4]
In the alarm systems divided into several partitions (subsystems), a single keypad
control over the whole system is possible. When depressed and held down, the keys
[1], [2], [3] or [4] switch over the partition the keypad is currently controlling. The control
panel will confirm receiving the command with three short beeps and the LED indicating
the partition served will start rapidly blinking if the partition is disarmed, or will be on with
steady light, if the partition is armed. Since that moment, the panel will recognize the
keypad the function was called from, as if it was connected to the given partition.