Satel Versa - Arming the Selected Partition; Quick Arming; Arming Without Delay; Denial of Arming

8 VERSA SATEL
The partitions to which you have access will be armed.
3.2.2 Arming the selected partition
1. Indicate the partition which is to be armed (press one of the keys: - partition 1;
- partition 2).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Backlight of the keys will start blinking, which indicates that the
code must be entered.
3. Enter the code.
4. Press the key or press again the key corresponding to the selected arming mode.
When the quick arming is available, the steps 3 and 4 are skipped.
3.2.3 Quick arming
The installer may permit arming without entering the code.
1. Indicate the partition(s) to be armed (press one of the keys:
- partition 1; -
partition 2; or - both partitions).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming).
You can switch the arming mode from the night mode to the full mode and from the
day mode to the full mode without entering the code. Otherwise, you will have to enter
the code – see “Arming the selected partition”.
The installer can configure the system so that the quick arming can be impossible, if
there is a violated zone in the partition, or a trouble has occurred in the system.
3.2.4 Arming without delay
When arming the system using one of the above mentioned methods, press and hold down
the arming mode selection key ( , or ) for about 3 seconds. The system will
become armed without delay, i.e. the delayed zones will act as instant ones (without any
exit/entry delay time).
In the day or night arming mode, the entry delay countdown may run, if the control
panel is so configured by the installer.
3.2.5 Denial of arming
The installer can configure the control panel so that initiating the arming procedure is
impossible, if:
 in the partition to be armed, at least one zone that must not be violated during arming (the
P
RIORITY option has been enabled for the zone by the installer) is violated,
 in the partition to be armed, at least one alarm zone is violated beyond the exit route,
 there is trouble in the system.
3.2.6 Failure of arming procedure
The installer can configure the alarm system in such a manner that it will not be armed, if at
the moment of completing the exit delay countdown:
 there is a violated zone in partition which was not violated when the arming procedure was
started,