10 VERSA SATEL
3.5 Triggering the alarm from keypad
The installer can permit triggering alarms from the keypad. To trigger an alarm, do the
following:
fire alarm – press for approx. 3 seconds,
medical (auxiliary) alarm – press for approx. 3 seconds,
panic alarm – press for approx. 3 seconds. The installer defines whether the loud
panic alarm (setting off the loud alarm signal) or the silent panic alarm (without the loud
signal) will be triggered.
3.6 Turning the CHIME on /off
The CHIME is five short sounds by means of which the keypad will inform you e.g. that
a door / window is open, when the system is disarmed. The installer defines which zones of
the alarm system can trigger the CHIME and whether it can be turned on/off by the users.
Press and hold down for about 3 seconds to turn on or off the CHIME signaling.
3.7 User menu
Enter the code and press to get access to the user menu. Which functions you can
start depends on your rights, as well as status and configuration of the system.
In order to quit the function and/or user menu, press . The keypad will quit the menu
automatically, if 2 minutes have elapsed since the last keypress.
3.7.1 Running the functions
The functions are numbered. To run a function, enter the digit or a sequence of digits, and
then press . The sequences of keys which are to be pressed to run each function are
presented in section “User functions list” (p. 12).
For example, to start the zone inhibiting function, enter the user menu and then press
.
3.7.2 “Step by step” programming method
In case of some functions (e.g. adding and editing users, configuring timers, etc.), the
programming is effected by using the “step by step” method. After calling the function and
selecting the item to be configured from the list, the first parameter available for programming
will be displayed. After pressing , you will go on to programming another parameter (if
you have entered some changes, they will be saved). After all parameters have been
configured, you will either return to the selection list or exit the user menu, depending on the
function. The
and LEDs of the first and second partition show the number of
programming step (see: table 1). Some programming steps may be sometimes not available.
3.7.3 Entering data
The changes entered will be saved after pressing the key. Use the key to quit
the function without saving changes.
Entering digits
To enter digits, use the numeric keys. The digits are presented by means of LEDs (up to 6
digits). A single digit is presented on four LEDs – see Table 1. LEDs 1-4 present the first
digit, LEDs 5-8 – the second, LEDs 9-12 – the third, LEDs 16-19 – the fourth, LEDs 20-23 –
the fifth, and LEDs 24-27 – the sixth digit.
To Next Page
Loading...
