20 VERSA SATEL
2. Step 1. Selecting user whose data are to be edited. You can make your selection by
using the and keys or by entering the user number (the LED designated by
the number of selected user should start blinking). Having selected the user, press .
You can press to interrupt the procedure of editing a user. Any changes made in
the steps ended by pressing the key will be saved.
3. Step 2. Changing user code. Proceed in the same way as when adding a new user.
4. Step 3. Selecting user schedule. Proceed in the same way as when adding a new user.
5. Step 4. Selecting partitions accessible to the user. Proceed in the same way as when
adding a new user.
6. Step 5. Editing 433 MHz keyfob. Press:
– , if you want to move on to the next step,
– and in turn, if you want to add a keyfob (the procedure is similar to that for
adding a 433 MHz keyfob to a new user, however, if the user had a keyfob before, the
control panel, during assignment of functions to the buttons, will suggest the same
functions as were assigned to the removed keyfob),
– and in turn, if the user has a keyfob and you want to edit functions
assigned to the keyfob buttons (the procedure is similar to that for assigning functions
after a 433 MHz keyfob has been added to a new user),
– and in turn, if you want to remove a keyfob.
Removal of the keyfob does not erase its settings (functions assigned to the keyfob).
The installer can remove all the 433 MHz keyfobs and their settings by using the
REM.RX K-FOBS function (SERVICE MODE 2. HARDWARE 1. KPDS. & EXPS.
9. REM.RX K-FOBS).
7. Step 6. Editing APT-100 keyfob. Press:
– , if you want to move on to the next step,
– and in turn, if you want to add a keyfob (the procedure is similar to that for
adding the APT-100 keyfob to a new user, however, if the user had a keyfob before,
the control panel, when assigning functions to the buttons and defining the rules of
confirmation, will suggest the same settings as for the removed keyfob),
–
and in turn, if the user has a keyfob and you want to edit functions
assigned to the keyfob buttons (the procedure is similar to that for assigning functions
after an APT-100 keyfob has been added to a new user),
–
and in turn, if you want to remove a keyfob.
Removal of the keyfob does not erase its settings (functions assigned to the keyfob
and rules of confirmation).
The installer can remove all the APT-100 keyfobs and their settings by using the
REM.ABAX KFBS function (SERVICE MODE 2. HARDWARE 1. KPDS. & EXPS. 8.
REM.ABAX KFBS).
– and in turn, if the user has a keyfob and you want to edit the rules of
confirmation (the procedure is similar as for defining the rules of confirmation after an
APT-100 keyfob has been added to a new user).
8. Step 7. Editing proximity card. Press:
– , if you want to move on to the next step,
To Next Page
Loading...
