Satel Versa - Selecting the Arming Mode; Programming the Telephone Numbers to be Notified

SATEL VERSA 23
3.14.3 Selecting the arming mode
1. Define whether and what arming mode is to be activated by the timer (press one of the
keys: - full arming; - night arming; - day arming; - timer does not
arm the partition). The LEDs indicate what selection you have made (LED 1 blinking – full
arm the partition).
arming; LED 2 blinking – night arming; LED 3 blinking – day arming; neither LED is
blinking – timer does not
2. Press . You will be taken back to Step 2.
3.15 Programming the telephone numbers to be notified
Programming the phone numbers from LED keypad is not recommended (only up to 6
characters are presented by means of LEDs; some characters are not presented at all
– Table 1, page 11, contains the characters that are presented).
1. Enter the user menu and press in turn .
2. Press in turn the suitable keys to select the telephone number to be edited (the phone
numbers to which voice messaging is not enabled are only available to the installer):
- telephone 1,
- telephone 2,
- telephone 3,
- telephone 4,
- telephone 5,
- telephone 6,
- telephone 7,
- telephone 8.
ilable characters are presented in Table 3). You can 3. Enter the telephone number (the ava
enter up to 16 characters. Some of the characters occupy two positions (a, b, c, d, # and
). If they are used, you can enter less characters than 16.
Characters available after next keystroke
key mode [ABC] key mode [abc]
1 # 1 #
2 B C 2 a b c
3 D E F 3 d
4 4
5 5
6 6
7 7
8 8
9 9
0
0
Table 3. Characters available in the keypad when entering telephone numbers (to change the
letter case, press key).