10 VERSA SATEL
medical (auxiliary) alarm – press for approx. 3 seconds,
panic alarm – press for approx. 3 seconds. The installer defines whether the loud
panic alarm (setting off the loud alarm signal) or the silent panic alarm (without the loud
signal) will be triggered.
3.6 Turning the CHIME on /off
The CHIME is five short sounds by means of which the keypad will inform you e.g. that
oor / window is open, when the system is disarmed. The installer defines which zones of a d
the alarm system can trigger the CHIME and whether it can be turned on/off by the users.
Press and hold down for about 3 seconds to turn on or off the CHIME signaling.
3.7 User menu
Enter the code and press to get access to the user menu. Which functions you can
In order to quit the function and/or user menu, press
start depends on your rights, as well as status and configuration of the system.
. The keypad will quit the menu
utes have elapsed since the last keypress.
of digits, and
automatically, if 2 min
3.7.1 Running the functions
The functions are numbered. To run a function, enter the digit or a sequence
then press . The sequences of keys which are to ressed to run each function are
presented in section “User functions list” (p. 12).
be p
For example, to start the zone inhibiting function, enter the user menu and then press
.
3.7.2 “Ste y step” programming method
In case of some functions (e.g. adding and e
p b
diting users, configuring timers, etc.), the
selecting the item to be configured from the list, the first parameter available for programming
will be displayed. After pressing
programming is effected by using the “step by step” method. After calling the function and
, you will go on to programming another parameter (if
aved). After all parameters have been you have entered some changes, they will be s
configured, you will either return to the selection list or exit the user menu, depending on the
function. The
and LEDs of the first and second partition show the number of
programming step (see: table 1). Some programming steps may be sometimes not available.
3.7.3 Entering data
The changes entered will be saved after pressing the key. Use the key to quit
the function without saving changes.
Entering digits
To enter digits, use the
digits). A single digit is p
numeric keys. The digits are presented by means of LEDs (up to 6
igit.
cimal characters
resented on four LEDs – see Table 1. LEDs 1-4 present the first
digit, LEDs 5-8 – the second, LEDs 9-12 – the third, LEDs 16-19 – the fourth, LEDs 20-23 –
the fifth, and LEDs 24-27 – the sixth d
Entering hexade
To enter digits, use the numeric keys, and to enter characters from A to F, use the and
keys (keep pressing the key until the required character appears). The characters are
presented by means of LEDs (up to 6 digits). A single character is presented on four LEDs –
To Next Page
Loading...
