12 VERSA SATEL
3.7.4 User functions list
Shown in square brackets are key sequences that enable starting the given function. The
functions that are only available after entering the service code have been specially
highlighted (white text against black background). The access to other functions depends on
the user rights. Highlighted with a frame are the functions which are available or change the
operating mode, if the GRADE 2 option has been enabled by the installer.
[1#] changing own code
[21#] adding new user
[22#] editing user
[23#] removing user
[3#] canceling telephone messaging
[41#] inhibiting zones
[42#] isolating zones
[61#] auto-arming deferment
[62#] programming the clock
[63#] programming the timers
[64#] programming telephone numbers to be notified
[65#] programming codes to acknowledge / clear messaging
[7#] checking troubles / checking partition, alarm, trouble status
[8#
[91#] starting zone test
2#] starting output test
lity of radio signal
] controlling the outputs
[9
[93#] checking the level / qua
[94#] starting manual test transmission
[99#] checking current supply voltage in modules
[90#] deactivating outputs / activating 21. DETECTORS RESETTING output
[00#] starting service mode
1#] starting programming via telephone communicator [0
[03#] starting local program ming
[04#] finishing local programming
ice code access rules
code access time
t
Change own code
[05#] defining serv
[06#] defining service
[07#] starting programming via Etherne
3.8
1. En r the user menu and prete ss in turn .
2. En r the new code, and thente press
.
U3.9 sers
There can be up to 30 users in the system. A person using the service code (installer
s, but his/her access can
ervice access rules” p. 28 and “Defining the service access
.
/ service technician), who is an additional user, has a special statu
be limited (see: “Defining the s
time” p 28).
To Next Page
Loading...
