Satel Versa - Trouble Handling Procedure; Trouble Memory and Clearing the Trouble Memory

SATEL VERSA 25
LED 8 - AUX supply output overloaded,
LE ith telephone or Ethernet
LED 10 - roblem with ing to Station 2,
LED 11 - mming AB rnet module initialization error /
thernet ne mmunication with device selected for
mmunicati o connection to SATEL server / MAC/ID error,
LED 12 - hort-circuit i us,
LED 13 - ntrol pane r
LED 14 - ontrol pane
LED 15 - iolation of tamper zone (TMP zone on control panel main board or 6. 24H
AMPER
type zone),
LED 16 - zone tamper
LED 17 - o long zone violation,
LED 18 - no zone violation
ED 19 - violation of 11. DETECTOR MASK or 19. TROUBLE type zones,
LED 27 low battery in user keyfob,
LED 28
LED 29 control panel restart,
LED 30 trouble in control panel processor system (HSE).
3.17.2 Troubl ocedure
Each trouble poses a danger to proper functioning of the alarm system and should be
repaired as soon as possible. If necessary, consult the installer.
(HSE), when you have
D 9 -
problem w reporting to Station 1,
p telephone or Ethernet report
ja AX system wireless devices / Ethe
E twork not available / no co
co on test (PING) / n
s n communication b
co l clock t ouble,
c l settings trouble,
v
T
,
to
,
L
LED 20 - low battery in wireless device,
LED 21 - no communication with wireless device,
LED 22 - expander tamper,
LED 23 - no presence of expander,
LED 24 - loss of 230 V AC power in expander,
LED 25 - no battery / low battery in expander,
LED 26 - expander supply output overloaded,
-
- expander restart,
-
-
e handling pr
In the event of failure of the control panel processor system
exited the 7. S function by using the key, the “Make VERSA panel YSTEM STATE
restart? 1=Yes” message will be displayed. Pressing the key will restart the
control panel and repair the trouble.
3.17.3 Trouble memo n ary a d cle ring the trouble memory
The installer defines whether only the current troubles are to be presented, or also those
nded. The keypad indicates the current troubles by steady-on LEDs,
r quitting the function:
which have already e
and the troubles that have ended – by blinking LEDs.
You can clear the trouble memory afte
1. Press to quit the function. The LED will start blinking rapidly.
2. Press to clear the trouble memory (pressing another key will cancel clearing the
TAMPER ALARM option is enabled in the control panel,
trouble memory).
If the SERVICE MESSAGE AFTER
only the installer can clear the tamper alarm memory.