18 VERSA SATEL
12. Output 12 state
Partition 2 LED is ON when partition 2 is armed
Partition 1 and 2 LED is ON when partitions 1 and 2 are armed
1 – Night arm LED is lit when partition 1 is armed in night mode
2 – Full arm LED is lit when partition 2 is armed in full mode
2 – Day arm LED is lit when partition 2 is armed in day mode
tion 2
Contact the installer to obtain in and output functions.
13. Arming: Partition 1 LED is ON when partition 1 is armed
14. Arming:
15. Arming: Partition 1 or 2 LED is ON when partition 1 or 2 is armed
16. Arming:
17. Partition 1 – Full arm LED is lit when partition 1 is armed in full mode
18. Partition
19. Partition 1 – Day arm LED is lit when partition 1 is armed in day mode
20. Partition
21. Partition 2 – Night arm LED is lit when partition 2 is armed in night mode
22. Partition
23. Partition 1 – Alarm LED is ON when there is alarm in partition 1
24. Partition 2 – Alarm LED is ON when there is alarm in parti
25. Partition 1 or 2 – Alarm LED is ON when there is alarm in partition 1 or 2
26. Trouble LED is ON when there is trouble in the system
255. NOT PRESENT LED will not be used for confirmation
formation on the zone types
24. g confirmation ed in the same
25. g confirmation for LED 3 in APT-100 keyfob. Proceed in the same
Step 6j. Selectin for LED 2 in APT-100 keyfob. Proce
way as in Step 6i.
Step 6k. Selectin
way as in Step 6i.
Pressing the key between Step 6a and 6k will cancel the keyfob adding, but will
not terminate the user adding procedure.
26. proximity card. If a device provided with proximity card reader is
stem, a proximity card can be assigned to the user. Press in turn
Step 7. Adding
installed in the sy
and (if a proximity card is to be assigned to the user) or only (if no proximity
d to the user).
27. rd additio
card is to be assigne
Step 7a. Selecting ca n method. Press (if the card code is
entered) or select the d means of which the card code
to be
evice, by will be read. The LEDs
ses ocorresponding to the addres f devices are steady on, and the
and keys
ed module will start allow you to select the device (the LED corresponding to the select
blinking). Having selected the device, press .
28. card.
e: “Ente ress
Step 7b. Adding proximity Depending on the selected method:
– enter the card code (se ring hexadecimal characters” p. 10) and p
,
– bring the card twice cl e reader (displayed messages will promose to th pt you what to
he car oximity card do). Remember that t d number will only be sent by the pr
arm/disarm device after the card is moved away from the reader.
Pressing the key in Step 7a or 7b will cancel the card adding.
3.9
.
.2 User editing
1 Enter the user menu and press in turn . User editing is effected by the
sented on the “step by step” method, hence the programming step number is pre and
LEDs of the first and second partitions (see: page 11, Table 1).
To Next Page
Loading...
