To Next Page
B
Barbara FinleyAug 29, 2025
How to fix dim print images on my SATO Label Maker?
- HHannah HessAug 29, 2025
If the SATO Label Maker displays dim print images, adjust the darkness level setting to increase the print head darkness.
How to fix dim print images on my SATO Label Maker?
If the SATO Label Maker displays dim print images, adjust the darkness level setting to increase the print head darkness.
What to do if my SATO Label Maker displays a buffer over error?
If your SATO Label Maker shows a 'Buffer over' error, it means the amount of data received exceeds the limit of the receive buffer, or the protocol is wrong. Correct the software on the host side or set the correct protocol to resolve this.
What to do if my SATO Label Maker shows a download error?
If your SATO Label Maker shows a download error, it means that you downloaded wrong data. Please, download again.
What to do if my SATO CG4 Printer shows 'Paper end' error?
If your SATO Printer displays a 'Paper end' error, it means the printer is out of paper. To resolve this, set the paper properly.
What to do if my SATO Label Maker has a cutter error?
If the SATO Label Maker cutter is not working, connect the cutter unit. If the cut operation was not performed successfully, set and feed the paper again.
What to do if my SATO Label Maker shows a sensor error?
If the SATO Label Maker shows a 'Sensor error', it might be due to a wrong sensor level, a wrong sensor type, or label meandering. Adjust the level or sensor type as needed.
What to do if my SATO Label Maker displays buffer near full?
If your SATO Label Maker shows a 'Buffer near full' message, it means the free space for receive buffer is low. Pause the data transmission on the host side and wait to have enough buffer space.
What to do if my SATO Label Maker displays an incorrect program error?
If the SATO Label Maker has an incorrect program error, it means that the download did not complete successfully. Download again.
How to fix incorrect label sensor selection on my SATO Label Maker?
If you selected an incorrect label sensor on your SATO Label Maker, set the sensor correctly by printer setting tool.
How to resolve incorrect label sensor selection on my SATO Label Maker?
If you have incorrect label sensor selection on your SATO Label Maker, set the sensor correctly by printer setting tool.
General| Print Method | Thermal transfer |
|---|---|
| Print Resolution | 203 dpi |
| Print Width | 104 mm |
| Media Type | Label, tag |
| Media Width | 25.4 mm to 114 mm |
| Media Thickness | 0.06 mm to 0.19 mm |
| Media Roll Diameter | 127 mm |
| Processor | 32-bit RISC |
| Memory | 8 MB Flash |
| Interfaces | USB, Serial |
| Optional Interfaces | Wireless |
| Power Source | 100-240 VAC, 50/60 Hz |
| Roll Core Inner Diameter | 25.4 mm |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Print Speed | 4 ips (101.6 mm/s) |
| Ribbon Core | 25.4 mm |
| Humidity | 20% to 85% (non-condensing) |
